You could save £130 on energy bills by dodging 'simple' mistake people make in winter

Woman adjusting radiator
-Credit: (Image: Getty)


You could be on course to spend an additional £130 on your energy bill this winter – if you don't avoid four simple blunders.

Google searches for “radiators are not getting hot” have soared a staggering 250% in recent weeks, but the answer might not be cranking the heat up further. Radiator specialist BestHeating has shared the mistakes that could be increasing your energy bills, and what to do about them.

The company says there are several problems which could be causing lofty energy bills and chilly heaters. Jessica Steele, heating technology expert at BestHeating said: "Approximately 80% of radiator issues, particularly when they fail to heat up properly, are typically simple and easy to fix.

READ MORE: Glasgow Willy Wonka experience organiser exposed as sex pest who told woman ‘you are my prey’

READ MORE: Gladiator II's Paul Mescal praised by former school as they delight fans with old student snaps of star

“The main problem is that many people are unaware of the common causes behind cool radiators, leading to panic and unnecessary plumber expenses. By shedding light on these frequent easy-to-fix issues, I hope we can help households across the UK improve their heating efficiency effortlessly in time for winter.”

Here are four common reasons why your radiators aren’t getting hot:

1. Air trapped in radiators

Air can get trapped in radiators, preventing hot water from circulating properly, causing the top of the radiator to stay cold. The solution for this is bleeding them. Jessica explained: “Using a radiator key, turn the valve at the top of the radiator to release trapped air. When water starts coming out, the air is gone, and you can close the valve.

“This should allow the hot water to flow evenly. Be sure to check your boiler pressure after this though, as it may need to be topped up.”

2. Faulty Thermostatic Radiator Valve (TRV)

A Thermostatic Radiator Valve (TRV) regulates the temperature of each radiator. If it’s stuck or faulty, it can block the flow of hot water. To check and clean the TRV, Jessica advised: “Ensure the valve is not stuck by trying to turn it to a higher setting. If it remains unresponsive, it might need to be cleaned with a soft damp cloth, lubricated with WD-40 or similar, or replaced.”

3. Radiator balancing issue

When some radiators are hot, and others remain cold, Jessica suggested: “It may be a balancing issue where the hot water is not evenly distributed across the system. Balance the radiators by adjusting the lockshield valve on the warmer radiators which is usually found at the bottom opposite the TRV.”

This will reduce the flow and allow more hot water to reach the colder radiators. This requires a small adjustment and testing over time to balance the heat.

4. Boiler pressure issues

The boiler may also be malfunctioning, causing insufficient hot water to circulate through the heating system. This is likely to be a result of low pressure in the boiler.

Ensure the boiler pressure is within the recommended range which is usually 1.0 to 1.5 bar. Jessica added: “If the pressure is too low, you can add water to the system through the filling loop.”

Experts believe these blunders could be adding an estimated £130 onto their heating bills, which is based on an average estimated saving from improving radiator efficiency in a typical UK household, factoring in reduced energy usage and lower heating costs after bleeding radiators to eliminate trapped air.

Consumer experts Which? shared a TikTok video detailing how to bleed a radiator using a screwdriver. In the comments section, people shared their thoughts.

One person quipped: “Bleedin' heck! ... or ‘bleeding hack!’” while someone else suggested: “get a bleed key, much easier than a driver” and someone else nervously added: “no, I’m scared”.